PATCH PARAMETERS
1. Press the SEQUENCER [EDIT] button to make it go dark.%
2. Hold down the [MANUAL (16)] button and select a parameter by pressing one of the numeric buttons
shown in the following table.%
3. Use the [VALUE] knob to edit the value.%
4. Press the [MANUAL (16)] button once again to exit patch parameter editing. !
BUTTON PARAMETER# # VALUE/EXPLANATION!
[1]# Portamento Switch # Smoothly changes the pitch from the first-played note !
# # # # to the next-played note. !
# # # # OFF, ON!
[2]# Portamento Time# Adjusts the time over which the portamento pitch change occurs.%
# # # # 0-255!
[3]# Bend Range## Specifies the pitch bend range in semitone units.%
# # # # OFF, 1-24!
[4]# Tempo Sync## Synchronizes the LFO’s RATE or the DELAY’s TIME to the tempo.%
# # # # OFF, ON!
[5]# LFO Waveform# Switches the LFO waveform. !
####!
# # # # Tri (Triangle wave), Sqr (Square wave), !
# # # # SA1 (Sawtooth wave1), SA2 (Sawtooth wave2), !
# # # # Sin (Sine wave), rd1 (Random wave1), !
# # # # rd2 (Random wave2)%
[6]# LFO Key Trigger# Specifies whether the LFO cycle is aligned with the timing at which you !
# # # # play the key (on) or is not aligned (off ).%
# # # # OFF, On !
#########* Saved as a patch setting. !
To Next Page
Loading...
