Step button [1]–[16]
In step sequencer mode, the [1]–[16] buttons are called “step buttons.” !
SELECTING/PLAYING PATTERNS
1. Hold down the [START] button and press a [1]–[16] button to select a pattern. !
The display shows the pattern number. !
* You can also select a pattern by holding down the [START] button and turning the [VALUE] knob. !
2. Press the [START] button to play the pattern.%
Each time you press the button, the pattern plays or stops. You can also select the next pattern while a
pattern is playing. When the current pattern finishes playing, the next pattern starts playing. !
CHANGING THE TEMPO
1. Press the SEQUENCER [EDIT] button to make it light. The display indicates the tempo. %
2. Use the [VALUE] knob to change the tempo. %
TURNING STEPS ON/OFF
1. Press the SEQUENCER [EDIT] button to make it light. %
2. Press the step [1]–[16] buttons that you want to turn on/off. %
Lit (on): The note that is entered for the step will play.%
Unlit (off ): The note that is entered for the step will not play.%
You can choose whether turning a step off makes that step a rest or causes playback to skip that step
and proceed to the next step (refer to “Sequencer Settings”). %
To Next Page
Loading...
