[6]# # Velocity Curve # Sets the keyboard’s touch.!
# # *1!
# # # # # LHT# # Sets the keyboard to light touch.!
#####(Light)!
# # # # # MED # # This is the standard keyboard touch !
# # # # # (Medium)# setting (default). !
# # # # # HVY# # Sets the keyboard to a heavy touch.!
#####(Heavy)!
[7]# # Auto Off# # 30# # The power turns offautomatically after # #
# # # # # # # 30 minutes (default value).%
# # # # # # # Auto Off does not occur while USB-!
#######connected. !
[8]# # LED Demo# # OFF# # Specifies the time until the LED DEMO !
# # # # # # # is shown. !
# # # # # 1 (1 min)# Default: 3 min ## # # !
# # # # # 3 (3 min)!
# # # # # 10 (10 min)!
[9]# # Chain Mode# # Although the JU-06A is four-note polyphonic, you can !
# # # # # increase the polyphony by using a MIDI cable to !
# # # # # connect two or more JU-06A units and turning Chain !
#####mode on. !
# # # # # OFF# # If Chain mode is on, the fifth voice and !
# # # # # # # subsequent notes are passed “thru” via !
# # # # # ON# # MIDI OUT.%
#######Default: OFF !
[10]# # Chorus Noise# # OFF # # Specifies the amount of noise when # #
# # # # # (Noise Off)# chorus is on.%
# # # # # # # OrG (ORIGINAL) reproduces the noise !
# # # # # HLF (Half)# of the original JUNO’s chorus (default !
#######value). !
# # # # # ORG!
# # # # # (Original)!
#####!
[11]# # Control Change#OFF# Specifies the output destination of the # # # #
# # # # # MIDI messages that are transmitted. !
#!
# # # # # USB# # when you edit patch settings (operate !
# # # # # # # the panel).%
# # # # # MID# # Default: USB !
# # # # # ALL!
To Next Page
