Roland JUNO-Gi - Compressor; Enhancer; Limiter

116
COMPRESSOR
Parameter Value Explanation
On/O OFF, ON
This parameter turns the compressor eect
on/o.
Sustain 0–100 This sets the sustain for the sound.
Attack 0–100 This sets the attack (onset) of the sound.
Level 0–100 This sets the volume level of the eect.
ENHANCER
Parameter Value Explanation
On/O OFF, ON
This parameter turns the enhancer eect
on/o.
Sens 0–100
Adjusts the manner in which the enhancer
will be applied relative to the input signals.
Freq 1.0–10.0 (kHz)
Adjusts the frequency at which the
enhancer eect will begin to be applied.
The eect will be made apparent in the
frequencies above the frequency set here.
Mix Level 0–100
Adjusts the amount of phase-shifted sound
of the range set by “Frequency” that is to
be mixed with the input.
Low Mix Level 0–100
Adjusts the amount of phase-shifted sound
of the lower range that is to be mixed with
the input. The frequency range in which
the eect is applied is xed.
Level 0–100
Adjusts the volume of the enhanced
sound.
LIMITER
Parameter Value Explanation
On/O OFF, ON Sets the limiter to ON or OFF.
Threshold -24–0dB
Adjust this parameter to match the signal.
Limiting will be applied to input levels in
excess of this level.
Attack 0–100ms
This sets the time it takes for the limiter to
go into eect once the input level exceeds
the threshold level.
Release 50–5000ms
Adjusts the time until when the limiter will
turn o after the input level falls below the
threshold level.