Roland JUNO-Gi - System Menu [6] (INFORMATION)

84
Parameter Value Explanation
Filter
Filter Type
Type of lter
OFF No lter is used.
LPF
(Low Pass
Filter)
This reduces the volume of all frequencies
above the cuto frequency (Cuto).
BPF
(Band Pass
Filter)
This leaves only the frequencies in the region of
the cuto frequency, and cuts the rest.
HPF
(High Pass
Filter)
This cuts the frequencies in the region below
the cuto frequency.
PKG
(Peaking
Filter)
This emphasizes the frequencies in the region of
the cuto frequency.
Cuto 0–127
Frequency at which the lter begins to have an
eect on the waveform’s frequency components
Resonance 0–127
Emphasizes the portion of the sound in the
region of the cuto frequency, adding character
to the sound.
LFO
LFO Rate 0–127 Modulation speed of the LFO
LFO Osc 1 Pitch
Depth
-63–+63
Depth to which the LFO will modulate the Osc
1 pitch
LFO Osc 2 Pitch
Depth
-63–+63
Depth to which the LFO will modulate the Osc
2 pitch
LFO Osc 1 Pulse
Width Depth
-63–+63
Depth to which the LFO will modulate the pulse
width of the Osc 1 waveform
* The Pulse Width is activated when “SQR” is
selected with Osc 1 waveform.
LFO Osc 2 Pulse
Width Depth
-63–+63
Depth to which the LFO will modulate the pulse
width of the Osc 2 waveform
* The Pulse Width is activated when “SQR” is
selected with Osc 2 waveform.
[3] (EXP)
Parameter Value Explanation
Expression
Range Min 0–127
Lower limit of the range of the Active
Expression.
The eect will be applied when the position of
your hand above the D Beam controller is lower
than this value.
Range Max 0–127
Upper limit of the range of the Active
Expression.
The eect will be applied when the position of
your hand above the D Beam controller is above
this value.
* By setting Range Max below Range Min you
can invert the range of change.
127
Range Max
0
Range Min
[4] (ASSIGN)
Parameter Value Explanation
User Assignable
Type
Function controlled by the D Beam controller
CC01–31, 33–95 Controller numbers 1–31, 33–95
BEND UP Controls the pitch.
BEND DOWN Controls the pitch.
USB SONG START The USB memory song player will start/stop.
RECORDER START The digital recorder will start/stop.
TAP TEMPO
Tap tempo (a keyboard tempo specied by
the interval at which you move your hand
over the D Beam controller).
AFTERTOUCH Produce the same eect as aftertouch.
Range Min 0–127
Lower limit of the range of the D Beam
controller. The eect will be applied when
the position of your hand above the D Beam
controller is lower than this value.
Range Max 0–127
Upper limit of the range of the D Beam
controller. The eect will be applied when
the position of your hand above the D Beam
controller is above this value.
* By setting Range Max below Range Min
you can invert the range of change.
System Menu [6] (INFORMATION)
Here you can view the JUNO-Gi’s software version.