33
Jun. 2011 JUPITER-80
Installing the Aftertouch and Cushions
1. Affix from the “Affixing Start Position” shown in the figure below.
Place the Aftertouch (white) against the guide bushing, and the SK-9 Cushions (green) against the chassis.
2. Apply Syrex to the Aftertouch 2-(a)/(b) areas.
Apply so that the 2-(a) cushion end is coated, and the 2-(b) sensor is coated.
fig.SK-10-aftertouch1-e.eps
3. As shown in the figure below, insert the sensor into the HI board’s connector and secure it with filament tape.
* Avoid covering the board’s filter with the filament tape.
fig.SK-10-aftertouch2-e.eps
2-(a)
2-(b)
16.8
SK-976 AFTERTOUCH-B
Affixing Start
Position
Sensor Protruberance
from High-pitch Side
Place against this.
SK-9 CUSHION 76P
Place against this.
SK-10 76P PWB HI ASSY
Aftertouch Connector
Inserted sensor here.
To Next Page
Loading...
