49
Jun. 2011 JUPITER-80
28. USB COMPUTER (Tested in Normal
Mode)
1. Make sure the unit’s power is switched off, then use a USB cable to
connect a computer running Windows and the unit.
2. Switch on the power to the unit.
If No JUPITER-80 Driver Is Installed on the Computer
Verify that the message “Found New Hardware. JUPITER-80”
appears on the computer’s screen, and the Found New Hardware
Wizard starts.
If the JUPITER-80 Driver Is Installed on the Computer
On the computer, at Control Panel, go to Sounds and Audio Devices,
and verify that the JUPITER-80 is detected.
3. If no problem is found, switch off the power to the unit.
This completes all testing.
To Next Page
Loading...
