37
Chapter 2 Printing
2-2 Starting Printing
2.
Load the instrument to be imprinted on the vise.
When using the table, go to P. 40.
Push the rear side of the vise (where the handle is placed) against the main unit.
Align the sides of the vise with the alignment marks and lower the front side of the
vise.
When the tabs on the bottom of the vise t into the holes on the unit, this completes mounting of the
vise.
Turn the ne adjustment dial to align the sides of the layers of the table.
Handle
Alignment mark
Table
Fine adjustment
dial
To Next Page
Loading...
