39
Chapter 2 Printing
2-2 Starting Printing
Press the laser pointer button.
The laser pointer is irradiated.
If the machine is idle for 5 minutes, the laser pointer
is automatically turned o.
Raise the lock lever.
Move the table so that the laser pointer points at the center of the area to be im-
printed.
To nely adjust the table position, use the ne adjustment dial. The table position is adjustable within
the range of ± 2 mm (0.08 in.).
Lower the lock lever.
If you print using the head cap, this completes loading of the instrument to be imprinted. Go to
"STEP 2: Making Prints."
If you use no head cap, go to Step
3.
in P. 42.
The position to which the laser pointer points coincides with the center of the work area in METAZAStu-
dio. By making the position to which the laser pointer points coincide with the center of the area to
be imprinted, you can print with the exactly same layout as the one displayed on the METAZAStudio's
work area.
Fine adjustment dial
The area to be imprinted
Lock lever
Laser pointer
Laser pointer button
To Next Page
Loading...
