Roland RD-800 - Managing Live Set Files; Saving Live Set Files to Memory or USB; Loading Live Set Files

Detailed Settings for Each Function
6. Move the cursor downward and select the destination for
saving the Live Set le.
Value Explanation
USER MEMORY
The data is stored in the RD-800’s user memory.
USB MEMORY
The data is stored on a USB ash drive connected to the USB
MEMORY/WLAN ADAPTOR port on the rear panel.
7. Press the [ENTER] button.
The conrmation message appears.
If you do not want to load the Live Set le, press the [EXIT/SHIFT]
button.
8. Press the [ENTER] button once again to save the Live Set
le.
The Live Set le is saved.
NOTE
• “Executing...” appears in the display while the save is in progress.
Be sure never to turn o the power.
• Do not disconnect the USB ash drive while data is being saved.
MEMO
If a le with the same name has already been saved, the
conrmation message “Overwrite OK?” appears. To overwrite the
Live Set le, press the [ENTER] button; to save the le under a
dierent name, press the [EXIT/SHIFT] button.
Calling Up Live Set Files (Live Set File Load)
Here’s how to load a previously saved Live Set le.
NOTE
The current settings are erased when a Live Set le is called up.
Be sure to save any settings you would like to keep rst before
calling up a Live Set le (p. 23).
1. In the MENU screen, select “Live Set File” and press the
[ENTER] button (p. 26).
2. Press the Cursor [ ] [ ] buttons to select “Load,” then press
the [ENTER] button.
3. Move the cursor to “Media” and select the media
(memory) from which the le is to be loaded.
Value Explanation
USER MEMORY
Data is loaded from the RD-800’s user memory.
USB MEMORY
Data is loaded from the USB ash drive connected to the rear
panel USB MEMORY/WLAN ADAPTOR port.
4. Move the cursor to “Live Set File” and use the [DEC] [INC]
buttons or the value dial to select the le you want to call
up.
5. If you want system parameter (p. 43) settings to also be
loaded, move the cursor to “Load System Parameters” and
choose “YES.”
The system parameters are saved in a Live Set le that has been
stored after the [WRITE] button was pressed to save the settings in
the RD-800.
6. Press the [ENTER] button.
The conrmation message appears.
If you decide to cancel without loading a Live Set le, press the
[EXIT/SHIFT] button.
7. Press the [ENTER] button once again to load the Live Set
le.
The Live Set le is loaded into the RD-800.
NOTE
• Be sure never to turn o the power while the load is in progress.
• Do not disconnect the USB ash drive while the le is being
loaded.
45