Roland RD-800 - Placing the RD-800 on a Stand

Placing the RD-800 on a Stand
Be careful not to pinch your ngers when setting up the stand.
If you want to place the RD-800 on a stand, use the Roland KS-G8 or KS-G8B.
Place the instrument on the stand as follows.
KS-G8/KS-G8B
Align the mark on the
RD-800’s rear panel with the
center of the stand
Seen from the rear
Align the seam in the RD-800’s
panel (on the bottom, near the
front) with the corners of the
stand’s rubber feet
Seen from the side
8