3. Assembly and Ink Filling
16
Step 6 : Connecting the Cables
Procedure
A
Insert the cable clamp.
B
Connect both the power cord and the Ethernet cable (commercially available).
Use a power plug adapter if the electrical outlet is a two-prong outlet.
WARNING
Perform this task with all power switches left switched off.
Failure to observe this instruction may cause the machine to move suddenly,
resulting in injury.
WARNING
Connect the machine to an electrical outlet that complies with this ma-
chine’s ratings (for voltage, frequency, and current).
Incorrect voltage or insufcient current may cause re or electrical shock.
WARNING
Connect the machine to ground.
This can prevent re or electrical shock due to current leakage in the event of
a malfunction.
Ethernet cable
(Category 5 or higher)
Ethernet
(1000BASE-T
recommended)
Cable clamp
Pass the power
cord through here.
Power cord
To Next Page
Loading...
