Roland TrueVIS VG-540 - Installing the Cutting Tool; Assembling the Cutting Tool

26
CAUTION
Be sure to perform operations as specied by the instructions, and never
touch any area not specied in the instructions.
Failure to observe these instructions may cause the machine to move suddenly,
resulting in injury.
CAUTION
Never touch the tip of the blade.
Doing so may result in injury. The cutting performance of the blade will also
be impaired.
Step 1 : Assembling the Cutting Tool
Required items
Blade holder Blade Pin
Procedure
A
Insert the pin.
Insert the pin to the position where its end sticks out about 3 to 5 millimeters.
Pin
B
Insert the blade.
Insert the blade into the hole.
Tip
Blade
4. Installing the Cutting Tool