33
F
When you have nished making the setting, press [ENTER].
G
Press [ ] to go back to the screen shown below.
NETWORK
SUBNET MASK
If you are using the computer and the machine on a one-to-one basis, this completes the settings to make
on the printer.
Press [MENU] to go back to the original screen. Then, proceed to "Step 3 : Make the Port Settings for the
Software RIP" (P. 34).
If you need to set the gateway address, proceed to the following procedure.
3. Set the gateway address.
A
Press [ ] to display the screen shown below.
NETWORK
GATEWAY ADDR.
B
Press [ ] twice to display the screen shown below.
GATEWAY ADDR.
000.000.000.000
C
Press [ ] or [ ] to select the address number.
D
Press [ ].
E
Repeat
C
and
D
to set [GATEWAY ADDR.] to "255.255.255.255."
For the value to enter for the gateway address, consult your network administrator. Here, "255.255.255.255"
is entered by way of example.
GATEWAY ADDR.
255.255.255.255
F
When you have nished making the setting, press [ENTER].
G
Press [MENU], to go back to the original screen.
To Next Page
Loading...
