14
Connections and driver installation
■ Installing the driver
Installation must be performed in the order of the USB Composite Device
driver and then the USB Audio Device driver. Use the following procedure
to perform the installation.
1
Turn on the power of your computer and start up Windows. Insert the
Microsoft Windows 98 CD-ROM into your CD-ROM drive, and use a USB
cable to connect the UA-30 to your computer. (p. 13)
The UA-30’s USB indicator will light. A USB Composite Device will be
detected automatically, and the Add New Hardware Wizard dialog box will
appear. Click [Next].
fig.02-01.e
2
When the display asks “What do you want Windows to do?”, select
“Search for the best driver for your device. (Recommended).” and click
[Next].
Since some computers are sold with the contents of the Microsoft
Windows 98 CD-ROM already in the hard disk, a Microsoft
Windows 98 CD-ROM may not have been included. If this is the
case, you will be able to install the driver without the Microsoft
Windows 98 CD-ROM.
If you are using Windows 98 Second Edition, use the Windows 98
Second Edition CD-ROM.
If this dialog box does not
appear, refer to
“Problems when
installing the USB
driver” (p. 40).
To Next Page
Loading...
