13
Connections and driver installation
Making connections and installing
the driver
■ Making connections
@P921
To prevent malfunction and/or damage to speakers or other devices, always
turn down the volume, and turn off the power of all devices before making
any connections.
It is not necessary to turn off the power of your computer. Use a USB cable to
connect the UA-30 to your computer before turning on the power of your
audio equipment.
(942)
fig.02-12.e
Before disconnecting the
USB cable or restarting
Windows, please close all
applications. You should
also turn down the
volume of any audio or
amp system that is
connected.
This unit is equipped with
a protection circuit. A
rief interval (a few
seconds) after power up is
required before the unit
will operate normally.
Stereo set
Powered Speaker etc.
Computer
UA-30
USB cable
LINE IN、AUX IN
USB
Port
USB
Port
LINE OUT
Stereo
Headphones
Audio
cable
To Next Page
Loading...
