Roland UA-30 - Digital Transfer from CD;MD;DAT to Your Computer (Digital Recording)

22
UA-30 Application Guide
Digital transfer from CD/MD/DAT to
your computer (digital recording)
Make connections as shown in the following diagram.
fig.03-02.e
* Set the recording sample rate of your recording application to the same setting as the
“Sample rate select switch”. For details refer to the owner’s manual for the
application you are using.
UA-30
LINE IN
LINE
OUT
OPTICAL
IN
DIGITAL OUTPUT
CD / MD / DAT
You must set this to
match the sample rate of
the device (CD/MD/DAT)
connected to
the digital output.
Set as follows:
If connected to the OPTICAL
IN connector → "OPT"
If connected to the COAXIAL
IN connector → "COAX"
Set to "DIGITAL"
Computer
USB
port
USB
port
USB cable
Optical digital cable
Audio cable
Stereo
Headphones
Provide separately as
suitable for your equipment.
When using a coaxial cable
to make connections, connect
it to the UA-30's
"COAXIAL OUT" connector.
Signal flow
Monitor speakers
If you change the position
of the Sample rate select
switch or the Recording
input select switch, you
must first exit all
applications including the
UA-30 D-Out Smoother
(p. 37). You should also
turn down the volume of
any audio amp system
that is connected.
Since the UA-30 supports
SCMS (p. 7), audio data
containing SCMS data
that is input to the digital
connector cannot be
recorded by the UA-30 to
your computer. It will be
output from the line
output jacks and the
headphone jack.)
If you wish to input from
the LINE IN or GUITAR/
MIC jacks, refer to p. 24–
p. 25. On the UA-30, it is
not possible to mix the
signal from these inputs
with the signal from the
digital input connector
and record them together.