25
UA-30 Application Guide
■
Recording guitar (vocal) mixed with the line inputs
With these settings, the guitar (vocal) will be mixed with the line inputs and
recorded on your computer.
Make connections as shown in the following diagram.
fig.03-05.e
Set the recording sample rate of your recording application to the desired
setting. (The available sample rates will depend on your application. For
details refer to the owner’s manual for your application.)
Use the “Line input adjustment slider” and “Guitar/Mic input adjustment
slider” to adjust the balance. If the LED above the slider lights red, use the
slider to lower the input level.
The UA-30 does not
support the miniature
microphone (condenser
mic) that may have been
included with your
computer or sound card.
UA-30
LINE IN
LINE OUT,
OUT PUT
LINE
OUT
LINE
IN
GUITAR / MIC
Select the device
(GUITAR or MIC)
that is connected
Computer
USB
port
USB
port
USB cable
Audio cable
Audio cable
MIDI sound module / CD / MD / DAT
Stereo
Headphones
Monitor speakers
The GUITAR / MIC
and LINE IN will be
mixed and output.
The GUITAR / MIC
and LINE IN will be
mixed and output.
The GUITAR / MIC
and LINE IN will be
mixed and output.
LINE input signal flow
GUITAR / MIC signal flow
Guitar
Microphone
Select "LINE+G/M."
If you change the position
of the Sample rate select
switch or the Recording
input select switch, you
must first exit all
applications including the
UA-30 D-Out Smoother
(p. 37). You should also
turn down the volume of
any audio amp system
that is connected.
To Next Page
Loading...
