Roland V-Synth GT - Controls Added to Matrix Control

38
Controls Added to Matrix Control
SW1 and SW2 (S1 and S2 switches) have been added to Source 1 and 2 of Matrix Control (V-Synth GT Owner’s
Manual; p. 92).
fig.MatrixS1S2.eps
Parameter
Value Description
Source 1, 2
(Matrix Control Source 1, 2)
Sets the MIDI message used to
change the patch parameter with the
Matrix Control.
OFF Matrix control will not be used.
CC01–31,
33–95
Controller numbers 1-31, 33-95
BEND Pitch Bend
AFT Aftertouch
+PAD-X Time Trip pad (horizontal direction from the center)
+PAD-Y Time Trip pad (vertical direction from the center)
PAD-X Time Trip pad (horizontal direction)
PAD-Y Time Trip pad (vertical direction)
TRIP-R Time Trip pad (center from the circumference)
BEAM-L D Beam controller (left)
BEAM-R D Beam controller (right)
KNOB1 Assignable Controller ([C1])
KNOB2 Assignable Controller ([C2])
VELO Velocity (pressure you press a key with)
KEYF Note Number
SW1 S1 switch
SW2 S2 switch
V-Synth_GT_v2_e1.book 38 ページ ２００８年１２月１７日 水曜日 午前９時５分