Roland VersaCamm VS-640 User Manual

Fully Utilize the Media Heating System
4
Part of Practice
100
Making the Temperature Setting for the Media Heating System
Procedure

Press

Press several times to display the left gure.
Press
.

Press to select [PRINT] (print heater) or
[DRYER]
Press
.

Press to select a temperature.
You can set to “OFF." When set to "OFF," the media heating system does
not operate at all.
Press to enable the setting.

Press to go back to the original screen.
FUNCTION
HEATER CONFIG
HEATER CONFIG
DRYER 34 C
DRYER
35 C OFF
PRINT HEATER: General Guide for Setting Temperature
You use this mainly to improve ink adhesion and inhibit smudging.
If the ink forms lumps or smudges, raise the temperature. Note, however, that a temperature that is
too high may degrade the media or cause it to wrinkle.
DRYER: General Guide for Setting Temperature
When ink drying is poor, raise the temperature. Note, however, that a temperature that is too high
may degrade the media or cause it to wrinkle.
W1200mm
SETUP SHEET
Current preset
temperature
Current temperature
of the dryer
100

Roland VersaCamm VS-640 Specifications

General

Print Technology	Piezo inkjet
Resolution	Maximum 1440 dpi
Interface	Ethernet (10BASE-T/100BASE-TX), USB 2.0
Power Requirements	AC 100 to 240 V ± 10%, 50/60 Hz
Media Width	64 inches
Cutting Speed	11.8 in/s
Ink Configuration	CMYK, Light Cyan, Light Magenta, White
Media Handling	Roll
Ink Colors	Cyan, Magenta, Yellow, Black, Light Cyan, Light Magenta, Metallic Silver, White
Media Thickness	Maximum 39 mil
Maximum Print Width	64 in (162.5 cm)