Roland VersaCamm VS-640 User Manual

Maintenance that Should Be Performed Daily
3
Maintenance
72
Cleaning
WARNING
Never use gasoline, alcohol, thinner, or any other ammable material.
Doing so may cause re.
CAUTION
Before attempting cleaning, switch off the sub power and wait until the
platen and dryer cool (approximately 30 minutes).
Sudden movement of the machine may cause injury, or hot components may
cause burns.
Wipe away any buildup of ink or grime on the media path and other locations as daily cleaning. In particular,
the pinch rollers, grit rollers, and platen are likely to get a buildup of grime. Clean by wiping with a cloth
moistened by neutral detergent diluted with water then wrung dry.
 This machine is a precision device, and is sensitive to dust and dirt. Perform cleaning on a daily
basis.
 Never attempt to oil or lubricate the machine.
Wipe away any buildup of ink
or grime on the media path.
Roller of the separating knife
Paper dust is likely to deposit on this
roller. Wipe the roller regularly.
Grit rollers
Remove buildup of media and
other material using a brush. Never
use a metal brush.
Pinch rollers
Periodically wipe away any grime. Failure
to clean properly may result in the trans-
fer of grime to the surface of media.

Roland VersaCamm VS-640 Specifications

General

Print Technology	Piezo inkjet
Resolution	Maximum 1440 dpi
Interface	Ethernet (10BASE-T/100BASE-TX), USB 2.0
Power Requirements	AC 100 to 240 V ± 10%, 50/60 Hz
Media Width	64 inches
Cutting Speed	11.8 in/s
Ink Configuration	CMYK, Light Cyan, Light Magenta, White
Media Handling	Roll
Ink Colors	Cyan, Magenta, Yellow, Black, Light Cyan, Light Magenta, Metallic Silver, White
Media Thickness	Maximum 39 mil
Maximum Print Width	64 in (162.5 cm)