Roland VG-99 - Setting the FC-300 Amp Control

54
Chapter 5 Using the VG-99 in Combination with an FC-300
This switches the FC-300’s AMP CTL 1 and AMP CTL 2 parameters
on and off.
When the guitar amp’s channel switch jack is connected to the FC-
300’s AMP CONTROL 1 jack (or AMP CONTROL 2 jack), you can
then switch the guitar amp channels with the VG-99’s AMP CTL1 (or
AMP CTL2) parameter.
1. Use the PATCH/VALUE dial to select the patch
you want to set.
2. Press [NAME/KEY/BPM].
3. Press [F4] (AMPCTL).
4. Use [F1] and [F2] or the F1 and F2 knobs to set
AMP CTL1 and AMP CTL2 to ON or OFF.
Setting the FC-300 Amp
Control
Available Settings
Description
OFF
The FC-300’s AMP CTL1 and AMP CTL2
parameters are set to OFF.
ON
The FC-300’s AMP CTL1 and AMP CTL2
parameters are set to ON.
VG-99_e.book 54 ページ ２００７年７月５日 木曜日 午前９時２２分