Roland VG-99 - Changing Pitch with Tremolo Arm (T-ARM)

80
Chapter 8 Other Functions
pedal, MIDI device, or any of a variety of other controllers.
You can press the D BEAM or RIBBON CONTROLLER [PITCH]
button to use T-ARM, which changes the pitch of the COSM guitar
like a tremolo arm.
1. Press [CONTROL ASSIGN]
2. Press PAGE [ ] [ ] to go to Page 2 for the D
Beam, or Page 3 for the ribbon controller.
3. Press [F1] (PITCH).
4. Press PAGE [ ] to go to Page 1.
5. Select T-ARM with [F1] (SELECT) or the F1
knob.
The D BEAM T-ARM or the RIBBON T-ARM screen appears.
* This step is not necessary if you are using the ribbon controller. In
this case, proceed to Step 5.
6. Use [F2] (SELECT) or the F2 knob in the D
Beam screen or [F1] (SELECT) or the F1 knob
in the Ribbon Controller screen to select the
channel to which you want to apply the effect.
7. Set each of the T-ARM parameters on Page 1
or Page 2
For more detailed information on the parameters that can be set,
refer to “PITCH” (p. 151), (p. 153).
8. Press [EXIT] several times to return to the Play
screen.
9. Press the D BEAM or RIBBON CONTROLLER
[PITCH] button, causing the indicator to light.
10. Use the D Beam or ribbon controller like a
tremolo arm to change the pitch.
* With D BEAM:T-ARM:SW or RIBBON:T-ARM:SW and “
BEAM:T-ARM:CONTROL and RIBBON:T-ARM:CONTROL set
as the target in Control Assign, you can control the T-ARM effect
using an external pedal, MIDI device, or any of a variety of other
controllers.
Changing the Pitch as with a
Tremolo Arm (T-ARM)
VG-99_e.book 80 ページ ２００７年７月５日 木曜日 午前９時２２分