Roland VS-1680 - Page 47

11. Press [F2 (STEP→)]. You can return to the previous screen by pressing [F1
(STEP←)].
12. Determine whether or not the output is to be sent to the AUX bus. Press
[ ], [ ], [ ], and [ ] to move the cursor. Rotate the
TIME/VALUE dial to adjust each of the values.
fig.02-23(rec_step5.eps)
13. Press [F2 (STEP→)]. You can return to the previous screen by pressing [F1
(STEP←)].
14. Determine how the output is to be sent. Press [ ], [ ], [ ], and [ ]
to move the cursor. Rotate the TIME/VALUE dial to adjust each of the val-
ues.
fig.02-24(rec_step6.eps)
AUX Switch
AUX Send Switch
AUX Send Pan/Balance
Cursor
Monitor Select
Equalizer Mode
Direct Out
Effect Insert
Chapter 2 Basic Operation
47
Chapter 2