Storing Track Bouncing Settings (Bouncing)
Select this when recording the performance data from multiple tracks onto a
number of other tracks. If you want to cancel the settings procedure while still in
progress, then press [F6 (EXIT)].
1. Press [EZ ROUTING].
The EZ Routing icon appears in the display.
2. Press [F4 (Exec)]. If “Exec” does not appear in [F4], first press [PAGE] until
“Exec” is displayed, and then press [F4 (Exec)].
3. Press [F3 (Bounc)].
fig.02-18(ez_con(rec).eps)
4. Determine which tracks are to be recorded onto other tracks as well as
which tracks will have other tracks recorded onto them. First, press the
channel SELECT button for any track you want played back, then press the
track channel STATUS button for any track to which you will record. You
can assign a single playback track to be recorded on up to two tracks.
Additionally, by pressing the SELECT button for any playback track not
assigned to be recorded on another track, you can have the playback track
assigned to the MIX bus (the signal is not recorded). Press [ ] and [ ]
to move the cursor. Rotate the TIME/VALUE dial to select the V-track to
which you want the source recorded or played back.
* Playback tracks that have Stereo Link set to “On” cannot be recorded to tracks on
which Stereo Link is set to “Off” with the EZ Routing.
fig.02-31(bou_step1.eps)
Chapter 2 Basic Operation
52
To Next Page
Loading...
