Roland VS-1680 - Page 51

12. Determine how the output is to be sent. Press [ ], [ ], [ ], and [
] to move the cursor. Rotate the TIME/VALUE dial to adjust each of the val-
ues.
fig.02-29(mix_step5.eps)
13. Press [F4 (Exec)].
A confirmation message appears in the display. Press [YES] if you want to set
the selected routing.
fig.02-24a(apply.eps)
14. Press [F3 (SAVE)].
The Routing Save screen appears in the display. Save the routing using the pro-
cedure described in Steps 5–8 of “Storing Routings as a Single List (Template)”
(p. 41).
Monitor Select
Equalizer Mode
Direct Out
Effect Insert
Chapter 2 Basic Operation
51
Chapter 2