Roland XC-540 - Media Take-up System Components; 2-1 Power On and Off Procedures

5. Attach the paper tube.

Pull the dancer roller back toward you.
v
Mount the paper tube and secure the arm in place.
First, t the paper tube securely onto the end cap on the same side as the right stand leg. Next, press
the end cap on the same side as the arm into the paper tube and securely t the end cap into the paper
tube. Finally, secure the arm in place using the arm retaining screw.
For the paper tube, use the included item. Using something other than the included item may result in
spinning without traction or other problems that impede media take-up.
Arm
Dancer roller
Paper tube
OK
Not
OK
Paper tube
End cap
End cap
Fit onto this securely.
Fit onto this securely.
Tighten the screw while
pressing down from above.
26
3. Assembling and Installing