Roland XV-5080. - Turning the Power on and off

12
Getting Ready to Play
Turning the Power On and Off
Turning On the Power
Once the connections have been completed (p. 11), turn on power to your
various devices in the order specified. By turning on devices in the wrong
order, you risk causing malfunction and/or damage to speakers and other
devices.
1
Before you turn the power on, check to make sure that:
• Are all devices connected properly?
• Are the volume levels on the XV-5080 and any amp or mixer that is
connected turned down to the lowest settings?
2
Turn on the power to connected SCSI devices.
3
Press the XV-5080’s [POWER] switch to turn on the power.
fig.00-010.e(power button)
4
Turn on the power to connected audio devices.
Turning Off the Power
1
Before turning off the power, confirm the following.
• Are the volume levels on the XV-5080 and any amp or mixer that is
connected turned down to the lowest settings?
• Have you saved your data, including data for any sounds you have
created? (Owner’s Manual; p. 194)
2
Turn off the power to connected external devices.
3
Press the XV-5080’s [POWER] switch to turn off the power.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
b
efore the unit will operate
normally.