45
Let’s Play Sounds From a Sampler Library
Connecting the CD-ROM Drive
fig.00-046.e
1
Turn off the power of the XV-5080 and any connected external
devices.
2
Using a SCSI cable, connect the XV-5080 and the CD-ROM
drive.
3
Set the SCSI ID with the SCSI switch on the rear panel. Any
number is acceptable as long as each device has a different
SCSI ID.
Make the settings as shown below.
* For more on the CD-ROM drive SCSI ID settings, please refer to the owner’s
manual for the device you are using.
SCSI ID
XV-5080: 1
CD-ROM Drive: 3
4
Set the CD-ROM drive’s terminator to ON.
* For more on the CD-ROM drive terminator settings, please refer to the owner’s
manual for the device you are using.
* For more on making SCSI connections, please refer to p. 239 of the Owner’s
Manual.
XV-5080
CD-ROM drive
SCSI
Cable
SCSI ID = 1 SCSI ID = 3
You can check the XV-
5080’s currently selected
SCSI ID in the SYSTEM
Info screen. (p. 216)
The SCSI ID switch settings
“8” and “9” cannot be used
with the XV-5080.
To Next Page
Loading...
