Roland XV-5080. - Getting Ready to Play; Installing the Wave Expansion Board; Precautions to Observe When Installing Wave Expansion Boards

3
Getting Ready to Play
Installing the Wave Expansion Board
The XV-5080 can be further expanded with the installation of up to eight
optional wave expansion boards (up to four SRX Series boards and four SR-
JV80 Series boards). Wave data is stored in these wave expansion boards.
Also stored are Patches and Rhythm Sets that use the Wave data from the
wave expansion boards, allowing these to be called up directly for use.
Precautions to Observe When Installing Wave
Expansion Boards
• To avoid the risk of damage to internal components that can be caused
by static electricity, please carefully observe the following whenever you
handle the board.
❍Before you touch the board, always first grasp a metal object (such as
a water pipe), so you are sure that any static electricity you might have
been carrying has been discharged.
❍When handling the board, grasp it only by its edges. Avoid touching
any of the electronic components or connectors.
❍Save the bag in which the board was originally shipped, and put the
board back into it whenever you need to store or transport it.
• Use a Philips screwdriver that is suitable for the size of the screw (a
number 2 screwdriver). If an unsuitable screwdriver is used, the head of
the screw may be stripped.
• To remove the screws, rotate the screwdriver counterclockwise. To
tighten the screws, rotate the screwdriver clockwise.
fig.00-001.e(screws)
• When installing Wave Expansion Boards, remove only the specified
screws.
• Be careful that the screws you remove do not drop into the interior of
the XV-5080.
• Do not leave the top cover in a detached state. Be sure to reattach it after
the Wave Expansion Boards have been installed.
• Do not touch any of the printed circuit pathways or connection
terminals.
• Be careful not to cut your hand on the edge of the installation bay.
• Never use excessive force when installing a circuit board. If it doesn’t fit
properly on the first attempt, remove the board and try again.
• When circuit board installation is complete, double-check your work.
tightenloosen