Roland XV-5080. - Using an External MIDI Device to Switch Performances

33
Try Out the Sounds
Using an External MIDI Device to Switch
Performances
To switch Performances, after matching the send channel for the external
MIDI device with the XV-5080’s Performance Control channel (Performance
Control Channel), send the Bank Select number and Program Change
messages.
Upon execution of Factory Reset, Performance Control Channel is set to
“16.” Here, set the external MIDI device’s send channel to “16,” then try
switching the Performance to PR-A:02 Seq:Pop.
1
Use a MIDI cable to connect the the MIDI OUT connector of
the external MIDI device to MIDI IN connector of the XV-5080.
2
Press the [PERFORM] button, getting its indicator to light.
The PERFORM Play page will appear.
fig.00-039.e_80
3
Set the external MIDI device’s transmit channel to “16.”
For instructions on making this setting, refer to the owner’s manual for the
external MIDI device.
4
Send a Bank Select MSB (Control Number 0) with a value of
“85” to the XV-5080.
5
Next, send a Bank Select LSB (Control Number 32) value of
“64.”
6
Send a Program Change with a value of “2.”
The Performance name appearing in the page changes to PR-A:02 Seq:Pop.