Roland XV-5080. - Page 23

23
Try Out the Sounds
1
Set the send channel of the sending MIDI keyboard to “1.”
For instructions on making this setting, refer to the owner’s manual for the
MIDI keyboard.
2
Press the [PATCH] button, lighting the indicator.
* As the receive channel is set to “1” when Factory Reset is executed, the following
step is not necessary.
Now play the MIDI keyboard to produce the sounds.
3
Press the [SYSTEM] button, lighting the indicator.
4
Press the [F3 (MIDI)] button.
The following page appears in the display.
fig.00-025.e_80
5
Press the [ ]/ [ ]/ [ ] /[ ] buttons to move the cursor
to the “Patch/Rhy Rx Channel” setting.
6
Rotate the VALUE dial or press the [INC]/[DEC] button to set
the value to “1.”
7
When you have finished making the settings, press the [EXIT]
button.
Play the MIDI keyboard to produce the sounds.