Roland XV-5080. - Page 38

38
Let’s Play Sounds From a Sampler Library
• Be careful that the screws you remove do not drop into the interior of
the XV-5080.
• Do not touch any of the printed circuit pathways or connection
terminals.
• Never use excessive force when installing a circuit board. If it doesn’t fit
properly on the first attempt, remove the board and try again.
• When circuit board installation is complete, double-check your work.
• Do not leave the cover removed. Be sure to reattach it after the SIMM
has been installed.
1
Turn off the power on the XV-5080 and any connected devices,
and disconnect any cables connected to the XV-5080.
2
Detach the cover on the top of the XV-5080.
fig.00-043.e
3
The order in which the slots are used when installing the
SIMMs depends on the number of SIMMs added. Refer to the
table below.
SIMM Slot Installation Order
Two cards: A, then B
One card: A
4
After confirming the position of the SIMM’s notch and its
orientation, insert the SIMM at an angle into the slot.
A
B
Screws to be removed