Installation
Quantum:EV OpenCharge EVQROCM-01-V01-R0 Installation and Operation Manual
Page 10 of 21 September 2020
Installation
WARNING: Electrical Power
Make sure electrical power is isolated BEFORE starting this procedure.
x Turn power OFF at SOURCE.
WARNING: Electrical Power
Make note of the electrical PHASE of the unit/socket to be connected.
Make sure all work is carried out appropriately and in accordance with the
current Electrical Wiring Regulations.
IMPORTANT: Installers and End Users must read and understand the content
of this manual before installation and/or use of the product.
Installation must only be performed by someone who is properly qualified and
competent to do so in accordance with the current legislation in force in the
geographical location of the installation.
x Advice provided in this manual does NOT override any legislation.
x If the advice in this manual is not understood, contact Rolec for further advice
and/or training BEFORE attempting installation/operation of the equipment.
x Rolec Services Ltd cannot accept any responsibility for improper installation or any
problems arising from improper installation.
NOTE: Damage to the equipment, connected systems or to property caused by
improper installation are the responsibility of the installer.
To Next Page
Loading...
Need help?
General
