4
R62 / R62T / R65 / R65T - Rev. A
ATTENTION! Before start up and operation ensure that the machine is compliant with the
purchasing order and complete with all the devices described in this manual and in any
commercial documentation, especially any safety devices.
ATTENTION! The machine described in this manual is for producing sheets from bread, pastry and
pizza dough by making the dough go through calibrating cylinders that feature alternating
forward and backward movement. This machine cannot be used for any purposes other than
those described above.
The manufacturing company will not be held responsible for any damage to properties and/or injury
to people or animals due to an incorrect use of the machine.
1.2 GENERAL INSTRUCTIONS AND WARNINGS
The manufacturing company declines any responsibility for damages to people, animals or
properties caused by failure to comply with the instructions contained in this manual and by the
failure to comply with the following indications:
•
Do not tamper with the guards and safety devices installed in the machine
•
Do not tamper with the guards and safety devices installed in the machine
•
Reposition all the protections and reset all the safety devices as soon as the reason why they
were removed/disabled is resolved
•
Do not use the machine for purposes and/or with loads and/or in a way that does not correspond
to that indicated by the manufacturer
•
Only use bread, pastry and pizza dough
•
Carry out daily checks on safety devices, level and state of technical fluids, if present, in addition
to checks on the general state of the machine
•
Carefully clean the machine on a daily basis
•
Adopt the necessary measures and precautions when carrying out adjustments, cleaning and
maintenance operations, etc. so that the machine or its components cannot be started by other
people, not even by accident
•
The location where the machine is to be installed must comply with European Directives as well
as with the laws and regulations in force in the country where the machine is installed and used
•
Respect any limit regarding climate conditions (see paragraph 2.2
TECHNICAL FEATURES
) and
permitted use
•
The employer, at whose production sites the machine is installed, must guarantee that operators
are suitably informed and trained on their specific tasks, on safe and correct use of the machine
and on general and specific risks in the workplace and/or job-related this manual can be a useful
support tool but cannot be considered exhaustive
•
Any manager who allows third parties to use the machine (for example the employer, and so
forth) must ensure that the machine is in good conditions, whole and fully functioning, especially
as regards safety equipment; should this not be the case, he must not allow it to be used and
must therefore put it out of service
•
During maintenance and cleaning operations (and any other such operation) operators must
wear snug clothes free of loose parts; they may not wear aprons, jackets, unbuttoned shirts, etc.
nor are they allowed to wear jewels (bracelets, necklaces, etc.) that may unhook or become
entangled in protruding parts; should they have long hair, they must use hairnets.
•
Should it be necessary to replace any parts, use original spare parts only by ordering them from
the manufacturing company; should non-original spare parts be used, the manufacturing
company relieves itself of any and all responsibilities for any resulting damages to people,
properties and/or animals
•
Any arbitrary modification to the machine, relieves the manufacturer of any and all
responsibility for any resulting damages to people, animals and/or things
To Next Page
Loading...