8
Continued from
previous page
Configuration Display Totalizer
Operation Totalizer [Units]
Mass Flow Elapsed Time [Seconds]
Density Totalizer Units [Units]
Solids Setup ExtReset [Enable/Disable]
Flow Rate Cutoff (%)
Proc Temp Reset Totalizer
Head Temp
Display Totalizer Remote Totalizer
Remote Totalizer
PD Counter
Units per Pulse
[number]
Alarms
Remote Tot Units
[units]
Auto Reference
Min Period [ms]
Hardware
Hart PD Counter
PD Count [read only]
PD Limit [number]
Alarm [number]
PD Units [units] [select]
Reset PD Cntr Source [variable]
Alarm Type [none,low,high,range]
Alarms
Setpoint [number]
Setpoint2 [number]
Alarm 1
Hysterisis [percentage]
Alarm 2
Alarm 3
Alarm on 4-20Ma
Alarm 4 [Select]
Alarm 5 None
Alarm 6 Underrange
Alarm 7 Overrange
Alarm 8 Freeze
Alarm on 4-20mA
System Hardware
Auto Reference
[read only]
CPU Card
Auto Ref [Enable/Disable] Slot 1 Details
Ref Delay [seconds] Slot 2
Auto Ref Dens. [number] Slot 2 Details
Slot 3
Hardware
Slot 3 Details
Slot 4
System Hardware
Slot 4 Details
Source Type Slot 5
Flow Rate Hardware Slot 5 Details
Proc. Temp Slot 6
Solids Adj. Hardware Slot 6 Details
Analog Out Config Slot 7
HART Output Slot 7 Details
Com1 Protocol [type] Slot 8
Slot 8 Details
Display
Display Details
Field Interface
HART DB Details
Details for Sys Hardware
Device Status
Serial Number
SW Major Rev
SW Minor Rev
HW Rev
Figure 3-2 Configuration Menus Continued
To Next Page
Loading...
Need help?
General