41
Safety Precautions
During installation the RSO will provide guidelines to
assure safety. Consider the information presented in
the Regulation/Safety Chapter of this manual, as well as
the following general guidelines:
The source holder must remain padlocked in the OFF
position until installation is complete.
Take all necessary precautions to assure that the source
holder is not dropped or damaged.
A specifically licensed individual MUST inspect the
installation prior to placing the source holder in the
ON position.
Always turn the source holder to the OFF position
when working around it, the detector, or the area
between these two components which is referred to as
the "measuring gap."
When the source holder is placed in the ON position,
avoid the "active beam."
To Next Page
Loading...
Need help?
General