15
Configuration Menu
The Configuration menu is used to access area configuration menus. It contains the following items:
ITEM FUNCTION
Operation Selecting this choice takes the user to the Operation menu.
Mass Flow Selecting this choice takes the user to the Mass Flow menu.
Density Selecting this choice takes the user to the Density menu.
Solids Setup Selecting this choice takes the user to the Solids Setup menu.
Flow Rate Selecting this choice takes the user to the Flow Rate menu.
Proc Temp Selecting this choice takes the user to the Proc Temp menu.
Head Temp Selecting this choice takes the user to the Head Temp menu.
Display Totalizer
Selecting this choice takes the user to the Display Totalizer menu.
Remote Totalizer Selecting this choice takes the user to the Remote Totalizer menu.
PD Counter Selecting this choice takes the user to the PD Counter menu.
Alarms Selecting this choice takes the user to the Alarms menu.
Auto Reference Selecting this choice takes the user to the Auto Reference menu.
Hardware Selecting this choice takes the user to the Hardware menu.
HART Selecting this choice takes the user to the HART menu.
System Selecting this choice takes the user to the System menu.
Operation Menu
The Operation menu is used to access the menus and variables that control the processing of the Mass Flow Gauge data. It
contains the following items:
ITEM
FUNCTION
Density Filtering Selecting this choice takes the user to the Density Filtering menu.
Flow Rate Filter Selecting this choice takes the user to the Flow Rate Filter menu.
Empty Clamp Selecting this choice takes the user to the Empty Clamp menu.
Detector Fault Selecting this choice takes the user to the Detector Fault menu.
Temp Comp Selecting this choice takes the user to the Temp Comp menu.
Linearization Selecting this choice takes the user to the Linearization menu.
Scan Time Shows the amount of time to accumulate each mass flow sample and allows the
user to change the time value.
To Next Page
Loading...
Need help?
General