Ropex CIRUS UPT-606 - DPV1 Protocol Extension (as of GSD Version V2.0)

Controller functions
UPT-606 Page 35
The various hold modes are shown below: The "hold mode" function must be activated
by means of the PROFIBUS parameter data
( section 9.7 "Parameter data" on page 30) or the
DPV1 protocol extension ( section 9.8 "DPV1 pro-
tocol extension (as of GSD Version v2.0)" on
page 35).
(Default setting: Hold mode off)
9.8 DPV1 protocol extension
(as of GSD Version v2.0)
Text in preparation.
9.8.1 Identification and maintenance
(I&M functions)
Text in preparation.
9.8.2 DPV1 alarm model
Text in preparation.
ACTUAL
temp.
1
T
t
t
0
0
Hold off
T
t
0
ACTUAL indication
Hold on
T
t
0
Hold 2 s
T
t
0
Hold Hold
Hold Hold
End of
heating phase
2 s 2 s
„ST“ bit
!