Ropex CIRUS UPT-606 - Page 41

Controller functions
UPT-606 Page 41
Error messages as of software revision 100
Action if machine
already operating,
HS element not chang.
Fault area

Fault area 
Fault area 
Fault area 
(loose contact)
Check power supply
Run RESET
 Kap. 9.2
Replace controller Replace controller Replace controller Replace controller
Check
plug-in jumper
Action
if machine started
for first time
Fault area

Fault area

Fault area

Fault area

(loose contact)
Check
power supply
Run RESET
 Kap. 9.2
Replace controller Replace controller Replace controller Replace controller
Check
plug-in jumper
Cause
I
R
signal missing
U
R
signal missing
U
R
and I
R
signals missing
Temperature step, down
Temperature step, up
Temperature too low/high
( section 9.7.12)
Frequency fluctuation,
inadmissible line frequency
Heatup time too long
( section 9.7.13)
Starting temperature too high
( section 9.7.11)
no line voltage/Sync-Sig.
Triac defective
Int. faut, contr. defective Int. faut, contr. defective Int. faut, contr. defective
Plug-in jumper for alarm
output wrong
STATUS
of alarm relay
(factory set.)
Energized
ALARM
LED
Lit
contin-
uously
Part 1 of 3:
Temp. 500°C
[°C]
33 66
100 133 166 200 233
Temp.
300°C
[°C]
20 40 60 80
100 120 140
Act. value
output;
Voltage [V]
0.66 1.33 2.00 2.66 3.33 4.00 4.66
Error
code
(101) (102) (103) (107) (108) (307) (308) (309) (310) (201) (202) (203) (304) (305) (901) (913) (914) (915) (916) (917) (918)
1 2 3 4 5 6 7