Controller functions
UPT-606 Page 43
Part 3 of 3: Error messages as of software revision 100
NOTE: The specified error messages are initially output as warnings (actual value output jumps back and forth between two values;
alarm LED blinks; alarm relay is de-energized). When the "START" signal is activated, the warning changes to a fault
(actual value output no longer jumps back and forth, see bold italic values; alarm LED lit continuously; alarm relay is energized).
Action if machine
already operating,
HS elem. not chang.
---
---
---
Action
if machine started
for first time
Fault area
,
check configuration
Fault area
,
check configuration
Fault area
,
check configuration
Cause
I
R
signal incorrect,
calibration not possible
U
R
signal incorrect,
calibration not possible
U
R
and I
R
signals incorrect,
calibration not possible
Temperature fluctuates,
calibration not possible
Ext. calibration
temperature too high,
calibration not possible
Ext. calibration
temperature fluctuates
calibration not possible
STATUS
of alarm relay
(factory set.)
Warning:
De-Energized
Fault:
Energized
(voltage value
at actual
value output
then no longer
changes)
ALARM
LED
Warning:
Blinks
slowly
(1Hz)
Fault:
Lit
contin-
uously
Temp.
500°C
[°C]
333
500
366
500
400
500
433
500
Temp.
300°C
[°C]
200
300
220
300
240
300
260
300
Act. value
output;
Volt. [V]
6.66
10
7.33
10
8.00
10
8.66
10
Error
code
(111)
(112)
(113)
(114)
(115)
(116)
10
11
12
13
To Next Page