HART Tri-Loop HART-to-Analog Signal Converter
5-4
CHANNEL 2
Channel Status (select one): M
Enabled M Disabled ★
Assigned Variable (select one)
(1)
: M Primary Variable M Secondary Variable
M Te r t i ar y Va r ia bl e ★ M Fourth Variable
Variable Range: Zero (4 mA) Value _________________________
(2)
Full Scale (20 mA) Value ____________________
(2)
Variable Units ________________________________________
(2) (3)
CHANNEL 3
Channel Status (select one): M Enabled M Disabled ★
Assigned Variable (select one)
(1)
: M Primary Variable M Secondary Variable
M Te r t i ar y Va r ia bl e M Fourth Variable ★
Variable Range: Zero (4 mA) Value _________________________
(2)
Full Scale (20 mA) Value ____________________
(2)
Variable Units ________________________________________
(2) (3)
(1) Verify process variable assignment for your instrument.
(2) This information must be completed for each enabled channel before the CDS can be accepted.
(3) Selected units must match device units or the Tri-Loop will alarm. Verify unit assignment for your instrument.
To Next Page
Loading...