Section
1-1
1 Introduction
USING THIS MANUAL
This manual provides installation, configuration, and troubleshooting
instructions for the Model 333 HART
®
Tri-Loop
™
HART-to-Analog
Signal Converter and for its operation with the HART Tri-Loop
Configurator Software. This manual also explains how to connect a
HART Tri-Loop to the Model 3095 MV Mass Flow Transmitter.
This manual consists of the following chapters:
Section 2
Installation
explains how to install the HART Tri-Loop. This includes an
installation flowchart, installation considerations, and field
installation. This section also explains how to set up the Model 3095
MV to send HART burst commands.
Section 3
Commissioning
explains how to install the HART Tri-Loop Configuration software, and
outlines the main steps to configure a HART Tri-Loop.
Section 4
Troubleshooting
provides troubleshooting suggestions for the most common operating
problems.
Section 5
Specifications and Reference Data
includes specification data for the HART Tri-Loop, ordering
information, and Configuration Data Sheet.
Appendix A
Model 3244MV
explains how to configure a Model 3244MV Smart Temperature
Transmitter for operation with a HART Tri-Loop.
Appendix B
HART
®
Communicator
explains how to use the Model 275 HART Communicator to
communicate with a HART Tri-Loop.
To Next Page
Loading...