20 • Physical Installation Ultripower User Guide (v4.0)
To connect the power cables to the Ultripower
1. Connect the female end of the provided AC power cable into the socket marked A on the Ultripower rear panel.
Figure 4.5 Ultripower — Power Connections
2. Connect the remaining power cable into the socket marked B.
3. Connect the supplied AC power cable into the power module.
4. Connect the supplied power cable’s three-prong male connector to Mains Power.
1 2
OUT
2 1
OUT
4 3
RESTART
ETHERNET
RESET
AC Circuit 1 AC Circuit 2
To Next Page
Loading...
