Rosslare AC-F Series - Entering Programming Mode

Programming
AC-F/G4x Series Installation and Programming Manual 33
5.1
Entering the Programming Mode
•
The controller must be in Normal mode to enter the
programming mode.
•
The factory default 4-digit programming code is 1234.
•
If a Programming code is not entered within 5 seconds, the
controller returns to Normal mode.
To enter Programming mode:
1.
Press # twice.
The left LED turns off and the right LED
turns red.
2.
Enter your 4-digit Programming code.
The right LED turns green.
5.2
Exiting the Programming Mode
•
Wrong entries may reset the controller back to Normal mode.
•
If no key is pressed for 1 minute, while in Programming mode,
the controller exits Programming mode and returns to Normal
mode.
To exit Programming mode:
1.
Press # twice to exit Programming mode at any time.
Red