Programming
34 AC-F/G4x Series Installation and Programming Manual
You hear 3 beeps.
The left LED turns green and the right LED
turns off.
Wrong entries reset the controller back to Normal mode.
While in Programming mode, if no key is pressed for one
minute, the unit exits Programming mode and returns to
Normal mode.
The Open code is mainly used as a method to quickly test the
Lock Strike relay during installation.
For security reasons, when the first user is added to the
controller or the Auxiliary code is changed, the default Open
code is automatically deleted; non-default codes are not be
erased automatically.
Open code does not function in Secure mode.
For wrong entries, you hear a long beep and the controller
returns to Normal mode.
Code 0000 erases and deactivate the open code.
The factory 4-digit default setting for the open code is 2580.
To Next Page
Loading...
Need help?
General
