Reader Functionality
AYC-Qx4 family manual Page 27
Return to Factory Default Settings
Warning:
• You must be very careful before using this command! This
will erase the entire memory and return all codes to their
factory default setting.
1) Enter Programming Mode.
2) Press “0” to enter Menu 0.
• The Transmit LED will
Flash red.
• The Program LED will
flash red.
3) Enter your 4 digit programming
code
• If the Programming Code is valid, all memory will be
erased, you will hear three beeps and the controller will
return to Normal Mode
• If the Programming Code is invalid you will hear a long
beep and the controller will return to Normal Mode
without erasing the memory of the controller
Replacing a Lost Programming Code
In the event that the Programming Code is forgotten, the AYC-
Qx4 may be reprogrammed in the field using the following
instructions:
1) Remove power from the reader.
2) Activate tamper by removing the reader from the wall or
removing the reader's case.
3) Apply power to the reader.
4) You now have 10 seconds to enter Programming Mode using
the factory default Programming Code 1234.
0
????
Mode/Transmit
Door/Pro
ram
Green
Mode/Transmit
Door/Program
Red
Red
To Next Page
Loading...
Need help?
General
