To Next Page

To Previous Page

Controller Functionality

AYC-Qx4 family manual Page 58

06 - Returns to factory defaults and sets a 6 digit code.

08 - Returns to factory defaults and sets a 4-8 digit code.

Note:

When choosing the 4-8 option, please note that you should

either enter zeros before the code, or press pound at the end

(for example if your code is 12345, enter either 00012345 or

12345#).

• Both the Mode and

Door LEDs will flash red.

3) Enter your 4-8 digits Programming

Code.

• If the Programming Code is valid, all memory will be

erased. You will hear three beeps and the controller will

return to Normal Mode.

• If the Programming Code is invalid you will hear a long

beep and the controller will return to Normal Mode

without erasing the memory contents.

Replacing a Lost Programming Code

Note:

• The AYC-Qx4 must be in Normal mode, otherwise this will not

work. Make sure that the Mode LED is green before

proceeding.

1) Remove power from the Power Supply Unit.

2) Press the REX Button on the Power Supply Unit.

3) Apply power to the unit with REX button pressed.

4) Release the REX Button.

5) You now have 15 seconds to program a new Programming

code into the Access Control unit using the default code

? ? ? ?

Mode/Transmit

Door/Program

Red

Rosslare AYC-Q Series User Manual

Other manuals for Rosslare AYC-Q Series