Rotary 1000 SERIES - Calibration Procedure; Runway Calibration Process

15
 Procedure:
1. Lower lift to the floor and
turn the disconnect switch
to “OFF”, Fig. 7.
2. Remove the wheels free
devices (rolling bridges)
from the lift.
WARNING
When the control is
in the calibration mode the control
does not equalize the runways. The
wheels free device (rolling bridge)
must be removed to avoid damage
to the wheels free device, lift, or
personnel.
3. Open the top panel, see Fig.
8, and move toggle switch
to “CALIBRATE”, Fig. 9 and
close top panel.
4. Turn the disconnect switch
to “ON” and press the
“RAISE” button as shown in
Fig 7 to raise both runways
to full rise.
5. Press the “LOWER” button
as shown in Fig. 7 to lower
both runways to the floor.
CALIBRATE
RUN
WARNING:
LIFT WILL NOT EQUALIZE IN CALIBRATE MODE. REMOVE ROLLING
BRIDGES BEFORE RUNNING CALIBRATE MODE. NEVER USE
CALIBRATE MODE WITH A VEHICLE ON THE LIFT. REFER TO
OPERATION INSTRUCTIONS FOR CALIBRATION STEPS
AND EMERGENCY LOWERING PROCEDURE.
NP966 Rev -
Switch Down for Calibration Mode
Switch And Label Inside Control Cabinet
Fig. 9
CalibrateRunways
Fig. 7
LOWER TO LOCKS
LIFT ON
LOCKS
WHEN LIT
Control Fault
Beeper
Raise Button
Lower Button
Lower To Locks Button
(Blinks When Lift Is Not
Resting On Locks)
Disconnect Switch
Run/Calibrate
Toggle Switch
Fig. 8