6
If you are not completely familiar with automotive lift maintenance procedures, STOP. Contact factory for
instructions.
ToAvoidPersonalInjury, permit only qualified lift service personnel to perform maintenance on this equipment.
•Always: Keep attaching bolts tight.
•Always: Keep locking latches free and oiled.
•Always: Raise lift when cleaning floor area with solvents and/or cleaning compounds.
•Always: Always keep runways and linkages clean. In salt belt or other corrosive environments, the lift must be washed down
weekly.
•Daily: Inspect front wheel stops and ramp/chocks for damage or excessive wear. Replace as required with genuine Rotary Lift
parts.
•Daily: Check locking latch operation and reset. Adjust per instructions or repair if required with genuine Rotary parts.
If locking latch is not heard when lift is raised:
A. Lower loaded lift onto lock, to check if lock is functioning. If lock is functioning, stop. If not, continue on
to “Step B”.
B. Check locking latch for damage or air line problem.
C. Repair and lubricate locking latch pivot points.
D. Lower lift about half way. Then raise lift and watch locking latch operation.
E. The air cylinder should allow locking latch to pivot in and out of the latch bar.
F. Push the “LOWER” button. This should retract air cylinder and locking latch from latch bar in-order to lower
lift.
•Weekly: Clean foreign debris from rear wheel slip plates and turning radius gauges by blowing out with shop air. DONOTGREASE
BALLBEARINGS.
•Monthly: Check anchor bolts to ensure they are torqued to 65 ft. lbs .
•Monthly: Check level of runway. Adjust per instructions.
•Monthly: Check position sensor cables. Replace if damaged.
•Monthly: Lubricate Guide on each turning radius with a dry film lubricant. Clean and lubricate more often as conditions warrant.
•Semi-Annually: Check fluid level of lift power unit and refill if required. If fluid is required, inspect all fittings, hoses and seals. Repair
as required.
•Semi-Annually: Spray inside of slider and lock tracks with Teflon (PTFE) lubricate with a paraffin wax additive. Clean and lubricate
more often as conditions warrant.
•Semi-Annually: Lubricate ramp/ chock hinge pins.
•ForWheelsFreeDeviceMaintenance Instructions see Wheels Free Device Installation, Operation and Maintenance Instructions in
the wheels free device box.
•Replaceall caution, warning, or safety related decals on the lift if unable to read or missing. Reorder labels from Rotary Lift - see
parts breakdown.
•OilFilterControlManifold: Replace filter after the first 6 months of operation and every 2 years thereafter. Installation torque is hand
tight.
MAINTENANCEINSTRUCTION
To Next Page
Loading...
Need help?
General
